News

Oct 03, 2023

COVID

“ A comprehensive overview of the market’s current trends, growth drivers, challenges, and opportunities is provided by

Sep 26, 2023

Former Dallas, Arlington Chief of Police David Kunkle Dies

David Kunkle, a longtime North Texas law enforcement officer and chief of police who had been diagnosed with Lewy body d

Sep 19, 2023

M.A. Ford adds to TuffCut 3D family

The M.A. Ford TuffCut 3D XFO and XFO-AL series tangential radius form allows for high accuracy finishing of large drafte

Sep 12, 2023

Women This Week: Climate Change Perpetuates Inequality for Women

Women Workers Harmed from Heat A new report by the Adrienne Arsht-Rockefeller Foundation Resilience Center at the Atlant

Sep 05, 2023

Billions for clean energy caught in a partisan tug of war

The next few months will be critical for the success or failure of the biggest environmental program in last year's clim

Aug 29, 2023

Playing With Fire

The New York Times headline from Hiroshima on May 19, 2023, spoke volumes to anyone paying attention: “Biden Pays Silent

Aug 22, 2023

Op

The Los Angeles Times embarrassed itself Sunday publishing an editorial presenting unsubstantiated climate myths while t

Aug 22, 2023

Stamping Die Essentials: First, determine the process of making a stamped part

Phuchit/iStock / Getty Images Plus Author’s Note: Since it’s been about 15 years since my Die Basics 101 series, I’ve be

Aug 20, 2023

Stamping Die Essentials: Deep drawing

Editor’s Note: This is the fifth in a series of articles presenting the fundamentals of stamping die design and construc

Aug 18, 2023

Stamping Die Essentials: Carrier strip design for progressive dies in metalforming

Phuchit/iStock / Getty Images Plus Editor’s Note: This is the third in a series of articles presenting the fundamentals

Aug 16, 2023

The Challenges of Precision Metal Stamping

Frank Dorman, Coreen Hamilton, Jordan Stubleski & Aiden English Tandem quadrupole mass spectrometry is being presented a

Aug 14, 2023

'Milk run' die maintenance for high

It is best to have the last part and last strip available for inspection when the tool goes in for maintenance. What is